Cuddeback EXCITE Owner's Manual download pdf (Page 17)

STEP 5 - KEY IS FOR CONTROLLING

CUDDEBACK

Press to view information and to set the

operating mode.

1) View Date and Time (figure 15) - Press

until the date/time is displayed on the LCD display.

2) View Images Saved - Press again. The LCD

will display [DO NOT REMOVE CARD] as the

Compact Flash Card is read. In a few seconds

the LCD will display the number of images saved

on the Compact Flash Card (figure 16).

3) Set the Camera Mode - Press again. One

of Cuddeback's 3 camera modes (Standby,

Test, and Live) will be displayed (figure 17).

Press or as needed to change the

camera mode.

a) Standby - Cuddeback will not trigger the camera.

b) Test Mode - The red LED will illuminate when

activity is sensed but the camera will not trigger.

c) Live Mode - Cuddeback will trigger the camera

when activity is sensed. The red LED will NOT

illuminate. About 45 seconds after [Live Mode]

is displayed the LCD will clear.

TIP - After Live Mode is displayed

there is a 45 second delay before

the motion sensor starts. This

gives you time to install the cover

and move out of the area without

triggering the camera.

After setting up Cuddeback, install

the cover and leave the area. You

can leave the Camera Mode in

Standby or Test and Cuddeback

will automatically arm itself within

12 minutes.

Figure 15

Figure 16

Figure 17

TestMode

Images

4/05/06

11:13 AM

1) Attach a TV or camcorder to the TV connector on

Cuddeback.

2) Press until [Images Saved] appears

(figure 24).

3) Press or . [Viewing] will appear on the

display (figure 25). An image will appear on

the TV.

4) View additional images by pressing or .

5) Press when you are finished viewing images.

To Erase an Image that is being Viewed on the TV

1) View an image with the TV as described above.

2) Press (C). The LCD will prompt [Clear Image C

= Yes] (figure 26).

3) To clear the image press .

4) To continue without clearing the image, press

, , or .

To Erase All Images on the Card

1) Press until [Images Saved] appears.

2) Press . The LCD will prompt [Clear All

Images C = Yes] (figure 27).

3) To clear all images press . The LCD will

prompt [Confirm? C = Yes] (figure 28).

4) To clear all images press . All images will

be cleared.

5) To continue without clearing the images, press

, , or .

Figure 24

Figure 27

Saved

Viewing

Clear

C = Yes

Figure 25

Figure 26

All Ima

C = Yes

Confirm?

C = Yes

Figure 28

Excite06OwnerManual 6/27/06 2:38 PM Page 12

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Comments to this Manuals

No comments

Cuddeback EXCITE Owner's Manual Page 17

Comments to this Manuals

Related products and manuals for Bridge cameras Cuddeback EXCITE