Cuddeback E FAMILY User Manual download pdf (Page 10)

Test Item

Press MODE until the

TESTS LED is illuminated.

Aer a short delay WALK

will be displayed and walk-test is enabled. When

test mode is enabled the RED LED (inside the ash

module) will illuminate

when a subject is detected.

Walk back and forth (not

toward) the camera to

verify the detection zone.

Pressing MORE from the WALK test will display

TEST CAM. See Appendix E: Troubleshooting,

Service & Support for instructions on how to use

these commands to troubleshoot and test your camera.

Command Item

Press MODE until the

COMMANDS LED is

illuminated. e rst menu

item is BATTERY which

displays the battery level. Press MORE to display

additional Command items. When a Command

item is displayed press UP or DOWN to activate

the command (if required).

BATT –––. Battery level displayed as FULL, GOOD,

LOW or DEAD. Press UP or DOWN to display

more information on battery status:

BD – Battery Days shows how long the camera

has been operating on this set of batteries. is

count is reset to 0 when the batteries are removed.

BI – Battery Images is a count of how many

battery images have been taken on this set of

batteries. is value is calculated based upon

Diagram of “Walk” test

16 17

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

No comments

Cuddeback E FAMILY User Manual Page 10