Cuddeback NoFlash Owner's Manual download pdf (Page 12)

STEP 5 - KEY IS FOR CONTROLLING

CUDDEBACK

Press to view information and to set the

operating mode.

View Date and Time (figure 15) - Press

until the date/time is displayed on the LCD display.

2) View Images Saved - Press again. The LCD

will display

[DO NOT REMOVE CARD] as the

Compact Flash Card is read. In a few seconds

the LCD will display the number of images saved

on the Compact Flash Card (figure 16).

Set the Camera Mode - Press again. One

of Cuddeback's 3 camera modes

(Standby,

Test, and Live)

will be displayed (figure 17).

Press or as needed to change the

camera mode.

a) Standby - Cuddeback will not trigger the camera.

b) Test Mode - The red LED will illuminate when

activity is sensed but the camera will not trigger.

c) Live Mode - Cuddeback will trigger the camera

when activity is sensed. The red LED will NOT

illuminate. About 45 seconds after

[Live Mode]

is displayed the LCD will clear.

TIP - After Live Mode is displayed

there is a 45 second delay before

the motion sensor starts. This

gives you time to install the cover

and move out of the area without

triggering the camera.

After setting up Cuddeback, install

the cover and leave the area. You

can leave the Camera Mode in

Standby or Test and Cuddeback

will automatically arm itself within

12 minutes.

Figure 15

Figure 16

Figure 17

TestMode

Images

4/05/06

11:13 AM

Time Lapse

12 Hours

Figure 73

PROGRAMMING THE TIME LAPSE INTERVAL

The interval between images can be programmed

from 1 hour to 96 hours.

1) After you select a Capture Mode of Time Lapse or

Both, press .

[Time Lapse Interval] will be

displayed.

(figure 73)

2) Press

to change the interval between

images.

3) When you have entered the correct time interval,

press to continue to the Time Lapse Start Hour.

PROGRAMMING THE TIME LAPSE START HOUR

You need to program the time of day you want the

time lapse image sequence to start. If you don't care

when the sequence starts, you can program the Start

Time to be Next Hour, which will begin the sequence

at the start of the next hour.

1) After you program the Time Lapse Interval press

[Time Lapse Start Hour] will be displayed.

2) Press or to change the start hour. The

range is any hour of the day and Next Hour.

To begin the time lapse operation you must enter

Live Camera as described on page 12.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Comments to this Manuals

No comments

Cuddeback NoFlash Owner's Manual Page 12

Comments to this Manuals

Related products and manuals for Bridge cameras Cuddeback NoFlash